First Choice PSMEL-2000 | 12/24V – 1 AMP Power Supply For 2 Exit Devices
Specifications
• PSMEL2000 shall operate up to two (2) 24VDC panic hardware devices simultaneously
• Each lock output shall have an adjustable relock delay timer
• It shall control a pair of doors simultaneously or independently two doors
• Relay for each output to trigger external relays, ADA push plate switches, etc.
• Delayed follower relays shall control automatic door operators for doors that are always locked or for doors that are unlocked during the business day
• Two un-switched auxillary voltage outputs shall provide/remove power to the lock outputs when activated
• A programmable FACP interface shall provide power/remove power to the lock outputs when activated
• Shall have LED status indicators monitor AC, FACP status & for lock output wiring supervision
• Intelligent logic shall provide protection against accidental shorting of lock outputs
PSMEL-2000 SMART VISUAL INDICATORS
• Output 1 & 2 = Red (ON) input LEDs indicate panic device status is energized (rapid blink/short or over current) (slow blink/open circuit)
• FAI = Green (ON) FACP Input Triggered (Alarm Condition)
• Battery Trouble = Red (ON) Battery Normal (slow blink/bad battery or no battery)
• AC Trouble = Green (ON) AC normal (slow blink/AC low or missing)
CODE/AGENCY LISTINGS
• UL File for Access Control Systems Units (UL 294)
• CUL Listed – CSA Standard C22.2 No. 205-M983, Signal Equipments
• CSFM – California State Fire Marshal Approved
BATTERY BACKUP
• Built-in charger for sealed lead acid or gel type batteries
• Automatic switch over to stand-by battery when AC fails
• Maximum charge current .65 amps
• 4AA batteries will make emergency stand-by at least 30 minutes
INPUT
• Input 115VAC 60Hz, 2.5 amp or 230VAC, 50Hz, 1.5 amps
• Two (2) N.O. Trigger Inputs
OUTPUTS
• Two (2) 24 VDC individually controlled lock outputs rated @ 1 amp each. Load connected not to exceed 1 amp.
• One (1) 24VDC @ .08 amps filtered regulated auxiliary output. (Not affected by FACP trigger)
• One (1)12 VDC @ .05 amp filtered regulated auxillary output. (Not affected by FACP trigger)
Note: Total combined current for the 24VDC outputs may not exceed 1.75 amp.
• Two (2) follower N.O. outputs for controlling ADA actuators/ accessories
• Two (2) momentary operator activation outputs
• Trouble output relay for indicating low/AC Voltage and battery trouble.
VISUAL INDICATORS
• Output 1 (On/Over/Open)
• Output 2 (On/Over/Open)
• FAI (On/Off)
• Battery (On/Off)
• AC Trouble (On/Low or Missing)
• AC Power (On/Off)
