First Choice PSMEL-2000 | 12/24V – 1 AMP Power Supply For 2 Exit Devices

First Choice PSMEL-2000 | 12/24V – 1 AMP Power Supply For 2 Exit Devices

Specifications

• PSMEL2000 shall operate up to two (2) 24VDC panic hardware devices simultaneously

• Each lock output shall have an adjustable relock delay timer

• It shall control a pair of doors simultaneously or independently two doors

• Relay for each output to trigger external relays, ADA push plate switches, etc.

• Delayed follower relays shall control automatic door operators for doors that are always locked or for doors that are unlocked during the business day

• Two un-switched auxillary voltage outputs shall provide/remove power to the lock outputs when activated

• A programmable FACP interface shall provide power/remove power to the lock outputs when activated

• Shall have LED status indicators monitor AC, FACP status & for lock output wiring supervision

• Intelligent logic shall provide protection against accidental shorting of lock outputs

PSMEL-2000 SMART VISUAL INDICATORS

• Output 1 & 2 = Red (ON) input LEDs indicate panic device status is energized (rapid blink/short or over current) (slow blink/open circuit)

• FAI = Green (ON) FACP Input Triggered (Alarm Condition)

• Battery Trouble = Red (ON) Battery Normal (slow blink/bad battery or no battery)

• AC Trouble = Green (ON) AC normal (slow blink/AC low or missing)

CODE/AGENCY LISTINGS

• UL File for Access Control Systems Units (UL 294)

• CUL Listed – CSA Standard C22.2 No. 205-M983, Signal Equipments

• CSFM – California State Fire Marshal Approved

BATTERY BACKUP

• Built-in charger for sealed lead acid or gel type batteries

• Automatic switch over to stand-by battery when AC fails

• Maximum charge current .65 amps

• 4AA batteries will make emergency stand-by at least 30 minutes

INPUT

• Input 115VAC 60Hz, 2.5 amp or 230VAC, 50Hz, 1.5 amps

• Two (2) N.O. Trigger Inputs

OUTPUTS

• Two (2) 24 VDC individually controlled lock outputs rated @ 1 amp each. Load connected not to exceed 1 amp.

• One (1) 24VDC @ .08 amps filtered regulated auxiliary output. (Not affected by FACP trigger)

• One (1)12 VDC @ .05 amp filtered regulated auxillary output. (Not affected by FACP trigger)

Note: Total combined current for the 24VDC outputs may not exceed 1.75 amp.

• Two (2) follower N.O. outputs for controlling ADA actuators/ accessories

• Two (2) momentary operator activation outputs

• Trouble output relay for indicating low/AC Voltage and battery trouble.

VISUAL INDICATORS

• Output 1 (On/Over/Open)

• Output 2 (On/Over/Open)

• FAI (On/Off)

• Battery (On/Off)

• AC Trouble (On/Low or Missing)

• AC Power (On/Off)