Command Access MLRK1-PDQ | Motorized Latch Retraction (MLR) Kit for PDQ 6200 Series Exit Device

FEATURES

• MM5 Smart Module: On board diagnostics with audible feedback for adjustment and power issues

• “PTS”: 5 second electronic adjustment for easy post installation adjustment

• Electric dogging rated for continuous duty - Auto re-engage if push pad is pulled from dogged position

• Low Current Draw - Field switchable to “High Torque” mode

• Up to 300’ wire run with 2-18ga wire - Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel

• 6” robust Molex Pigtail + 6’ Power lead to easily connect to power supply lead • Request-to-exit kit available

• 3-year “no hassle” warranty

SPECIFICATIONS

Voltage:

• Voltage range – 24V +/- 10%

• System protection – unit shutdown when voltage exceeds 28VDC

• Average Current Peak: 900A

• Average Current Hold: 215mA

• PTS adjustment – approx. 1/4”

Wire Run:

• 300’ with 18ga wire

Product Details:

• Weight: 2 Lbs

Device Cutdown Details:

• 36” & 48” - Minimum 8.5” of Filler Plate

Command Access MLRK1 Series Latch Retraction Kits Product Reference Chart

Command Access MLRK1-PDQ | Motorized Latch Retraction (MLR) Kit for PDQ 6200 Series Exit Device

The MLRK1-PDQ is a practical and cost-effective way to convert a mechanical PDQ 6200 series device to an electrified latch pullback device while maintaining the UL listing. An easy-to-install motor-driven kit installs in moments. It is equipped with PTS technology allowing for an easy post-installation adjustment of the latch/latches. Last but not least, it features an updated MM5 module with improved torque & 1 Touch PTS!

FEATURES

• MM5 Smart Module: On board diagnostics with audible feedback for adjustment and power issues

• “PTS”: 5 second electronic adjustment for easy post installation adjustment

• Electric dogging rated for continuous duty - Auto re-engage if push pad is pulled from dogged position

• Low Current Draw - Field switchable to “High Torque” mode

• Up to 300’ wire run with 2-18ga wire - Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel

• 6” robust Molex Pigtail + 6’ Power lead to easily connect to power supply lead • Request-to-exit kit available

• 3-year “no hassle” warranty

SPECIFICATIONS

Voltage:

• Voltage range – 24V +/- 10%

• System protection – unit shutdown when voltage exceeds 28VDC

• Average Current Peak: 900A

• Average Current Hold: 215mA

• PTS adjustment – approx. 1/4”

Wire Run:

• 300’ with 18ga wire

Product Details:

• Weight: 2 Lbs

Device Cutdown Details:

• 36” & 48” - Minimum 8.5” of Filler Plate

Command Access MLRK1 Series Latch Retraction Kits Product Reference Chart