Command Access MLRK1-VD22 | Motorized Latch Retraction (MLR) Kit for Von Duprin 22 Series Exit Device

FEATURES

• Next Generation MM5 Smart Module: On board diagnostics with audible feedback for adjustment and power issues

• “PTS”: 2 second electronic adjustment for easy post installation adjustment. Simplified further with a push button to engage programming & shorter program sequence.

• Standard Torque Mode: Now capable of pulling all types of devices, even the difficult tall Vertical Rods doors!

• Electric dogging rated for continuous duty - Auto re-engage if push pad is pulled from dogged position

• Up to 300’ wire run with 2-18ga wire - Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel

• 6” cable with robust Quick Molex Connector for MM5 module to 6’ Power lead to easily connect to power supply lead.

• Works on all 22 series devices

SPECIFICATIONS

Voltage:

VOLTAGE RANGE – 24 TO 28 VDC

SYSTEM PROTECTION – UNIT SHUTDOWN WHEN VOLTAGE EXCEEDS 28VDC

STANDARD - AVERAGE CURRENT PEAK: 900MA, AVERAGE CURRENT HOLD: 215MA

PTS ADJUSTMENT – APPROX. 1/4”

Wire Run:

• 300’ with 18ga wire

Device Cutdown Details:

NEW 36” MODEL - MAX CUT 5”

NEW 48” MODEL - MAX CUT 9”

Command Access MLRK1-VD22 Matrix

Command Access MLRK1 Series Latch Retraction Kits Product Reference Chart

Command Access MLRK1-VD22 | Motorized Latch Retraction (MLR) Kit for Von Duprin 22 Series Exit Device

The new MLRK1-VD22 is a practical and cost-effective way to convert a mechanical Von Duprin 22 series device to an electrified latch pullback device. The retrofit kit will maintain all UL listings on the device and is backed by CAT’s 3-year no hassle warranty. It easily hooks into the dogging tail piece and is secured with (2) screws, in a matter of seconds. The only hole you’ll need to drill is for the wire raceway. Push to Set (PTS) allows for an easy post-installation adjustment of the latch/ latches. A built-in REX switch on all units! Last but not least, the Kit features our updated MM5 module, energy conscious while still being capable of getting the tough jobs done!

FEATURES

• Next Generation MM5 Smart Module: On board diagnostics with audible feedback for adjustment and power issues

• “PTS”: 2 second electronic adjustment for easy post installation adjustment. Simplified further with a push button to engage programming & shorter program sequence.

• Standard Torque Mode: Now capable of pulling all types of devices, even the difficult tall Vertical Rods doors!

• Electric dogging rated for continuous duty - Auto re-engage if push pad is pulled from dogged position

• Up to 300’ wire run with 2-18ga wire - Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel

• 6” cable with robust Quick Molex Connector for MM5 module to 6’ Power lead to easily connect to power supply lead.

• Works on all 22 series devices

SPECIFICATIONS

Voltage:

VOLTAGE RANGE – 24 TO 28 VDC

SYSTEM PROTECTION – UNIT SHUTDOWN WHEN VOLTAGE EXCEEDS 28VDC

STANDARD - AVERAGE CURRENT PEAK: 900MA, AVERAGE CURRENT HOLD: 215MA

PTS ADJUSTMENT – APPROX. 1/4”

Wire Run:

• 300’ with 18ga wire

Device Cutdown Details:

NEW 36” MODEL - MAX CUT 5”

NEW 48” MODEL - MAX CUT 9”

Command Access MLRK1-VD22 Matrix

Command Access MLRK1 Series Latch Retraction Kits Product Reference Chart